11.45" diameter, series wound DC motor with a double ended shaft. Our WarP 11 ™ motor comes set with advanced timing CCWDE. Of the most notable changes, we have a very large com and utilize the large style, very high quality brushes.

The com bars are more securely attached to the arbor, so they will be less likely to lift. The drive shaft is bored for a pilot bearing and drilled & tapped for a 5/16 - 18 bolt. The tail shaft also has a 1/4 - 20 bolt hole to mount tach sensors or secure couplers and accessories. Again, we have duplicated the ADC 9" mounting bolt pattern allowing clients to use preexisting mounting adapters. Class "H" insulation is used throughout the motor. The drive shaft and tail shaft have standard keyways cut into them. This motor is also available at a better price point to end users.

Technical Information:

NetGain recommends a maximum vehicle weight of 4400lbs or less when using this motor coupled to a transmission.
Maximum operating voltage 170V, recommended voltage 150-160V
Field adjustable timing available as an option - e-mail for details
Weighs just 73 pounds more than a WarP 9 (223lbs)
The same mounting pattern as a WarP 9 or an ADC 9” motor
One hour HP rating = 43 HP @ 72 volts DC
135 Ft. pounds torque - 72 volts, 452.8 amps
Overall length = 21.044", case length = 17.27"
5500 RPM
Exceeds class "H" insulation standard for temperatures
Large style brushes, factory preset at over 90% contact
Drive and tail shafts keyed - pilot bearing hole with 5/16 - 18 mounting hole